For Use With 1937-1948 Ford Spindles

Spindle Mounting Center to Center Width: 3.300"
Mounting Flange to Tie Rod Center: 6 1/8"
Tie Rod End Taper Angle: Ford 7 Degree from Bottom Side

A must have part for any traditional hot rod. 1-1/2" dropped side steer arm to keep the steering arm geometry correct when using a dropped axle. Made from 17-4 stainless steel. The thru bolt design allows it to work with a wide selection of brake kits and even comes dimpled around the grease fitting to allow for a 45 deg. fitting. It really doesn't get any nicer. 

NOTES & TIPS:
Taper can be drilled out with a 5/8" drill bit to accept 5/8" heim joint or rod end.
Depending on the axle width, drop, spindles, and tie rod end combination used - a shim or spacer may be required between spindle and steering arm for the tie rod end to clear the axle.